A mini-split is a small heat pump with two pieces: a fan coil on an interior wall and a condenser outside, joined by a line set through the wall. It heats and cools one room or a garage without ducts. It is not a window unit, and it is not a plug-in space heater. Even the 115-volt models want a dedicated circuit. The 230-volt models need 230-volt power. A power strip is the wrong plan for either.

The listings below say heat pump. None of them state a low outdoor temperature, so do not treat them as cold-climate systems that will carry a house through a hard freeze until you have read that rating in the manual. SEER2 is the cooling-efficiency number. Higher costs less to run in summer. The square-foot figures are the makers' coverage claims for an ordinary room, not a drafty garage with a 12-foot ceiling.

A straightforward 115-volt, 12,000 BTU place to start is this Senville LETO. If you only need a blast of heat for a workout, a shop heater is the smaller project on heaters for a garage gym.

A person relaxing indoors

What to look for

Volts

115-volt models can go on a dedicated 115-volt circuit. 208/230-volt models cannot. Look at the panel you have before you look at the color of the indoor head.

BTU and the room

9,000 BTU is the smaller room. 12,000 BTU is the one-ton class, often listed around 750 square feet. High ceilings, sun, and a leaky garage all shrink that coverage.

Line set

A pre-charged condenser is set up for a limited line length. A long run, a tall lift, or a kinked line is a technician's job, not a longer extension cord.

Who controls it

The remote and, on some models, an app control this head. A central thermostat and its room sensors do not automatically run a mini-split.

The LETO is the one-ton, 115-volt class mini-split with Alexa, which is the combination most single rooms need. Twelve thousand BTU is enough for a large bedroom, a studio, or a well-sealed one-car space, and it is not a promise for an open garage in January. Wall mounted means the indoor unit goes high on an exterior wall, close to where the line set can leave. Alexa is convenient and it does not change the electrical. You still need a proper circuit and a place outside for the condenser, with airflow and a pad it will not sink into. Read the heating low-temperature limit in the manual before you remove the old heater.

Drop to 9,000 BTU for a smaller bedroom or an office. The ROVSUN listing gives you Wi-Fi, 20 SEER2, 115 volts, and a pre-charged condenser. Twenty SEER2 is a strong cooling-efficiency number in this group. Pre-charged helps the install only within the line length the manual allows. Wi-Fi lets you turn the room on before you get home. It does not let you skip the hole in the wall or the dedicated circuit. This is the wrong size if the listing you compared was a 12,000 BTU unit for a 750-square-foot room.

This COSTWAY is the plain 12,000 BTU, 115-volt, 20 SEER2 unit, with a listed coverage up to 750 square feet. Treat 750 as the maker's figure for a normal room. A sunroom or a garage will feel smaller than that number. Buy it when you are happy using the included remote and the price is better than the Wi-Fi COSTWAY below. The install is still a wall bracket, a line set, a condensate drain that actually slopes out, and an outdoor unit that can breathe.

This is the COSTWAY to compare with the one above, not a second system to buy. Same 12,000 BTU, 20 SEER2, and 115 volts, plus Wi-Fi, Alexa, and a kit. Take this one if you want the app and the hardware in one listing. Take the other if it is cheaper and you do not care about Alexa. A kit is brackets and lines, not a permit and not a guarantee that the electrical panel has space. Lay the line set out before you punch the wall so you are not a foot short.

The Garvee is the 230-volt exception. It is 9,000 BTU, 18.5 SEER2, with Wi-Fi, and the coverage claim is up to 450 square feet. Do not order it for a house that only has a spare 115-volt breaker. 208/230 volts is a different circuit. The smaller BTU rating fits a bedroom, which matches the 450-square-foot claim better than an open living room. Wi-Fi is the convenience. The voltage is the decision.

Mountman is another 115-volt, 12,000 BTU heat pump, at 19 SEER2, with the same style of 750-square-foot claim. Nineteen SEER2 is a step under the 20 SEER2 COSTWAY and ROVSUN listings and still a normal modern number. Choose it when the price and the included hardware beat those, and the room is a one-ton room rather than a whole floor. Keep the outdoor unit out of a corner that recirculates its own air. Discharge air needs a clear path.

This listing leads with efficiency: 22 SEER2, 12,000 BTU, 115 volts, R32 refrigerant, Wi-Fi, and a kit. Compare the seller and the return terms as carefully as the SEER number. Twenty-two SEER2 is the highest cooling-efficiency figure in this group, which matters if the unit will run all summer. R32 is the refrigerant named on the listing. Leave refrigerant work to someone certified. Your part of a careful install is the wall, the drain, the pad, and the correct breaker, or hiring that out.

The last 12,000 BTU system is a pre-charged inverter heat pump at 19 SEER2 and 115 volts, listed for both heating and cooling. Inverter means the compressor can run at varying speed instead of only on or off, which is how these systems stay quieter and hold a temperature. Pre-charged has a line-length limit in the manual. Use it for a single room on a 115-volt circuit. Then read the low-ambient heating line before you depend on it as your only heat in a cold snap.

This Does Not Replace a Central Thermostat

A mini-split uses its own remote. Sensors and thermostats for a ducted system are a separate choice, on smart thermostats with room sensors.

What You Are Installing

A mini-split is two pieces: a fan coil high on an interior wall and a condenser outside, joined by a line set through the wall. It heats and cools one room or a sealed garage without ducts. It is not a window unit, and it is not a space heater you plug into a power strip. Even a 115-volt model wants a dedicated circuit. A 208/230-volt model needs that voltage. Look at the panel before you look at the indoor color.

The square-foot numbers on the box are the maker's claim for an ordinary room. High ceilings, sun, and a leaky garage shrink that coverage. Nine thousand BTU is a bedroom or an office. Twelve thousand BTU, about one ton, is the larger single room, often listed around 750 square feet of normal space.

Heat in Cold Weather

These listings say heat pump. They do not state a low outdoor temperature. Do not assume the unit will carry the room through a hard freeze until you have read that rating in the manual. In mild cold, a heat pump is efficient. In deep cold, some of them lean on electric backup or simply put out less heat. Keep the old heater until you have seen a cold week.

The Install Details That Matter

A pre-charged condenser is set up for a limited line length. A long run or a tall lift is a technician's job, and refrigerant work belongs to someone certified. The condensate drain has to slope out or the indoor unit will drip. The outdoor unit needs a pad and a clear path for its discharge air, not a tight corner that recirculates. The remote, and on some models an app, runs this head. A central thermostat does not.